Slab leaks are recognized to happen as a consequence of leaking pipes located beneath concrete walls as well as the foundation of the residence. Slab leaks take moment before they origin any noticeable damage. However after sometime you will begin to notice wetness on your floors and carpets. At this point do not waste any time instead do what is necessary in order to correct the situation by calling any North Charleston slab leak detection professional. Otherwise if you leave it unattended then you will end up spending more money to correct the damage to your home’s foundation.
Fixing a slab leak is not as difficult as most people would think. The process begins with locating the area where the leak is coming from then mark it. Then take away the flooring within that area, this should be done with care to avoid causing unnecessary damage. Penetrate the concrete using a drill bit and make sure the drilled hole is large enough for your hand to penetrate thereby allowing you to reach out and touch the leaking spot on the pipe. Once you find the trouble spot enlarge the whole around that area to give you adequate room to repair the pipe.
Shut off the water from the main switch then cut and remove the affected part of the pipe and attach a new pipe on that spot by welding. Once the damage has been taking care off cover up the hole with slab then gives it a couple of days to dry before you can begin the work of fixing the floor. As a home owner it is important for you to find ways through which you can detect slab leaks on time and prevent further damage to your foundation. One of them includes the use of a Charleston slab leak detection contractor.
As earlier mentioned it is very important for a homeowner to quickly respond whenever they notice any part of the floor that is ever wet. Your promptness will help to prevent extensive damage to your home as well as your foundation. It will also mean reduced cost to salvage the situation.
Slab leaks take place in residences which are build on concrete foundations. These houses have water pipes under the foundation which take water in and out of the house. But if there is any leak in these pipes then it becomes very difficult to detect and repair such pipes.
Most of the times you come to know about slab leaks when they have already caused heavy damage. So to prevent Charleston slab leak detection, you should regularly check for such leaks and repair them as soon as possible. You can detect hot water leaks by walking barefoot on the floor and if you notice any warm area then it indicates a hot water leak. If you can listen to noise of water dripping in the home even after finishing all plumbing equipment’s then this can point out a water leak.
If there is moisture or mold growth under the carpet then it indicates that water is leaking inside the floor and as it has nowhere else to go so it is moving upwards and accumulating under the carpet. Leaks in main line can be detected by checking the water pressure in the main line. Even if there is even a pin sized hole in the main line then it would reduce water pressure significantly and waste a lot of water. This can be noticed if you check your water bills for the past couple of months. If you notice a large increase in water usage then it indicates that there is a water leak in your main line.
Most of the slabs have a width of four feet so you will need to use a drilling machine to drill a hole and do it carefully as well so that you don’t cause any further damage. Locate the exact location of the leak and enlarge the hole to mend the pipe. Switch off the water supply by closing the main valve and cut the broken portion with a cutter.
Fix a similar pipe to the one cut off or in case of copper pipes weld the broken portion properly. Do not seal the hole for a couple of days and keep monitoring the leak for a few days. If you are completely convinced that the leak has been fixed properly then fill the hole with mixed concrete and cover the hole with a slab. Even after following all above tips if you are still not able to repair the leak then you need to call a North Charleston slab leak detection professional who will use advanced Leak Detection System for detecting leaks and repair them properly.
Taking care of one’s home nowadays is very important. Attending to minor issues immediately can give homeowners a great deal of savings and convenience especially when reliable and competent contractors handle the problems. One of the most common problems in every home is a wet basement – a case where water begins to dominate the basement due to some specific structural problems. Repairing a house’s foundation from the outside is always the best and most practical solution in preventing wet basements.
Why do basements leak? Most homeowners are not even aware of the probable causes of basement leak repair and typically, water dominates the basement due to several natural, structural or wear and tear causes. Some homeowners immediately assume that there is something wrong with their plumbing system when water starts to enter the basement but this is not always the case. Basement leaks might be caused by the high water content of the area where the house is built. This natural cause may further be aggravated by the changing climate and during spring, run-offs are very common and water might begin penetrating the basement.
Poor soil drainage, weak bearing soil and soil compaction can also cause basement leaks. It is also important for homeowners to place their plants at a good distance from their homes because maturing vegetation can damage the foundations and increase the rate of deterioration. Drilled holes for plumbing and electrical systems can also cause water intrusion. Failure of the sump pump, clogged troughs and spouts and sewage system back-ups can also cause problematic basement leaks.
Basement leaks can cause bad odors and health hazards to the family and can lead to allergies and diseases if the problem is not fixed right away. Molds and mildew will start building up in the foundations and can aggravate the deteriorating conditions of the house. For homeowners who desire to sell their houses in the future, basement leaks can pull the price down and may lead to loss of property value.
Accidents due to the presence of water in the electrical wiring system might endanger the lives of family members. Water can also damage furniture and appliances, increasing the cost of leak repair and replacements for the home. The sooner these leaks are attended, the better. It is very important to keep in mind that cracks, clogged passages, plumbing issues and other causes of basement leaks will not eventually repair or be resolved on their own, but will lead to further damage and deterioration in the future, so, you need to hire a professional leak repair in Charleston. Keeping homes in good condition and a safe and healthy place to live in requires homeowners to fix leaks and other structural problems as soon as they appear and competent contractors will definitely minimize cost and increase the longevity of one’s home.
There are numerous reasons why you may be facing the problem of a water heater. Before you proceed to dismantle the water heater to find out what is wrong, it is important to consider certain points so that you do not waste your time and effort.
If your water heater is brand new or if it is still within the warranty period, then it is advisable not to tinker with the device on your own. There is a possibility that your actions may void the warranty and you may end up with a faulty water heater, zero warranty and additional expenditure in your hands.
Just as you should be careful about tinkering with a brand new heater, you should be careful about trying to repair a very old heater yourself. Chances are high that the old water heater will be a rusty contraption with complicated mechanisms. Not only do you run the risk of damaging the heater beyond repair, you also face the risk of causing some serious damage to yourself in the process.
You should try and repair the water heater that is leaking only if you are confident of handling a wide range of problems from a leaking rubber valve to a leak repair in the storage drum itself. In case of a leaking rubber valve or a gasket, you just have to replace the same by getting a new one from a hardware store. On the other hand, a leaking drum is a more serious affair and may involve with the replacement of the drum or replacement of the heater as a whole.
Further, you should also be in a position to fit the drum back into the heater and make it fully functional all over again. If this is not done, you may end up spending a lot more by getting a professional to do not just the repair on the drum but also to repair the damage that you have done to the heater.
It is advisable to make use of the World Wide Web to get more information on the problems that usually affect your heater brand. If a particular problem occurs on a regular basis and if you have read many complaints in this regard on the web, it is advisable to get a professional at the very beginning.
On the other hand, if the problem is not very common and if other persons have successfully repaired the problem without calling the professional, you can give it a try yourself. The important thing is that you should not be in a hurry to initiate leak repair in Charleston without adequate preparatory work.